MODEL 01280P: Has a concave buffing block to maintain full contact with the curved surface of aluminum pontoons.BE SURE TO SELECT THE RIGHT MODEL. Maintaining full contact with the aluminum surface while buffing will insure better results, less time and effort buffing and fewer replacement ALUMABUFF PADS™.The POWER POINT LINEAR BUFFER™ is an air operated buffing machine that requires compressed air from a compressor. It requires 90 psi, but can run on slightly less. Most portable compressors with a 3 to 5 gal tank and 100 psi, or larger, are adequate. The POWER POINT LINEAR BUFFER™ has a 15 ¾” buffing block that operates back and forth in a linear motion, moving approximately 1 inch at up to 3,000 strokes per minute, free speed, and slower under pressure. It has dual cylinders to eliminate dead spots and stalling and operates at low noise and vibration levels.
The back and forth linear motion is important as it follows the grain to clean the stains and streaks without cutting across the grain which removes a layer of aluminum. With a little practice controlling the speed and pressure, you should be able to restore your aluminum pontoon or boat in one pass. Heavily oxidized aluminum may require repetition until the aluminum is bright and shiny again.
The POWER POINT LINEAR BUFFER™ uses a Velcro Hook Strap mounted to the pad assembly to accommodate the special ALUMABUFF PADS™ that are designed for optimum efficiency when used with ALUMABUFF™. The pads with the special micro fibers, cleans the surface as well as getting into the recesses to clean them as well. ALUMABUFF™ contains HYPEXINE™, a special leaching agent that brings the stains to the surface so they can be easily and quickly removed. Removing streaks, stains, tarnish and oxidation from aluminum is fast, easy and much cleaner with this system. It can reduce the time it takes to restore your aluminum by 90%.
The POWER POINT LINEAR BUFFER™ uses a Velcro Hook Strap mounted to the pad assembly to accommodate the special ALUMABUFF PADS™ that are designed for optimum efficiency when used with ALUMABUFF™. The pads with the special micro fibers, cleans the surface plus it gets into the recesses to clean them as well. ALUMABUFF™ contains HYPEXINE™, a special leaching agent that brings the stains to the surface so they can be easily and quickly removed. Removing streaks, stains, tarnish and oxidation from aluminum is fast, easy and much cleaner with this system. It can reduce the time it takes to restore your aluminum by 90%. ALUMABUFF™ is water based and free rinsing so it’s not necessary to degrease the surface prior to applying ALUMETRON™ clear coat. Just rinse it clean with a pressure washer or garden hose and brush.
Reviews
There are no reviews yet.